PLEASE READ THE COMPLETE
INSTALLATION INSTRUCTIONS BEFORE
BEGINNING THE TASK
- The pressure transducer
records up to 140psi or 10
bar. It has a 1/8" x 27
NPT thread, and a single
blade connection to the oil
pressure gauge.
- The transducer kit comes
complete with adapters that
will allow fitment to
1/4" x 18, 3/8" x
18 and 1/2" x 14
mounting holes. The sender
should not be overtightened
on installation, but if
problems with sealing are
experienced then a little
PTFE tape can be used on the
threads, making sure that the
PTFE does not prevent a good
earth connection between the
body of the transducer and
it's mounting position.
|
