|
Caution:
Disconnect the battery cable prior to any
installation
Mounting
- When mounting the clock in a panel cut a
clearance hole of either 52mm (2.05")
diameter or 60mm (2.375") depending on
the clock model purchased.
- Insert Clock into hole and secure with
fixing bracket, washers and thumb nuts
provided, after conneting to the electrical
system.
Wiring Installation
Connect terminal (A) to a positive 12 volt
permanent supply (battery positive) through a 3
amps fuse and (B) to zero volts (battery
negative).
Setting Operation
Note there are two alternative
designs of setting mechanism dependant on the
model you have purchased:-
- Front operated button through the face of
the clock window.
- Remote operated button connected by
approximately 300mm of wire through the back
of the case. (some clocks have both a front
button and a remote button - in which case the
front button will be a "dummy" and
the clock is set by the remote button). The
remote button can be mounted (6mm hole) on the
instrument panel or discretely out of sight
dependant on the operational and aesthetic
preferences of the user.
Setting Time
Note to advance the time the clock must be
connected to the power supply of the vehicle ( see
wiring diagram.)
- To advance the time one minute, press the
set button once.
- To advance the time more than one minute,
press the set button and hold until the
desired time is reached.
Illumination
Caution: MAXIMUM power of lamp is
2.2watts and it is ESSENTIAL to push the lamp /
lamp holder fully into the lamp tube at the rear
of case.
- Assemble bulb and holder.
- Install bulb and holder fully into the lamp
tube at the rear of case.
- Connect one wire/terminal from the lamp
holder to the switched 12 volts illumination
supply and the other wire/terminal to zero
volts (battery negative)
|
